Model : GIUNONE - Equalizing - Stentering Machine 

This is an indispensable machine in the fabric finishing sector. It is used
to bring all types of fabric and knits evenly to the right width, giving them a
high quality appearance. As the fabric passes through the machines various work
phases, it is constantly held on the selvages by two pin chains made of
stainless steel. The machine has an 8 mt. real work zone, of which 3.5 mt. are
divergent and 4.5 mt. parallel. In the divergent zone the fabric is advanced by
cylinders (general advance) and in addition by 

two lateral rubberized wheels with indipendent motors with adjustable speed. In
the high temperature vapor tunnel made of stainless steel, the fabric undergoes
the slackening of its fibers giving it the softness necessary in order to raise
it to the required width. Condensation which may form is eliminated with an
anti-condensation device. In the parallel zone which is provided with a forced
hot air drying furnace, the fabric is thermally set, after which it is brought
to room temperature by passing

through a forced air cooling zone. This is followed by the detachment from the
non-tension pin chain and the rolling onto a cardboard roll with the length
attached. The fabric output can also be lap (the machine is supplied with a lap
rolling machine) or, with the advantage of being non-stop, it can feed a
successive rolling machine. A very important particular is the possibility of
requesting when ordering a longer parallel zone, thus increasing the drying
capacity of the furnace and assuming the characteristics of the Little Stenter.



Specifications:

Work width : 1000-2500 mm

Speed : 0-50 mt/1

Vapor consumption : 50-200 Kg/h

Installed electrical power : 18 Kw